LuiseLesperance885

Clear the Area

You need to have to eliminate every thing you can from the floor location you are going to refinish. Sofas, curtains, tables, rugs, and so on. One more, usually overlooked, crucial factor is to block as a lot of the airflo...

Whether you have just discovered a hardwood floor below your old carpeting or the wood floor you installed is searching a small beat, refinishing is the ideal alternative to bring out it is inner beauty. Right here are the actions you require to take to refinish your floors on your own.

Clear the Region

You want to remove every little thing you can from the floor location you are going to refinish. Sofas, curtains, tables, rugs, and so on. An additional, often overlooked, essential issue is to block as significantly of the airflow by means of the region as achievable. Whilst your finish is drying any airborne particles will stick and grow to be component of the floor. Something left in the area or these surrounding it must be appropriately protected whilst sanding. Dust covers and plastic blocking doorways are two of the ideal techniques to accomplish this.

Before Sanding

You want to go over your floor and fill in any cracks or gaps in the wood. Use wood putty in visible locations and caulk along the baseline if necessary. If your floor was beneath carpeting, use diagonal pliers to eliminate any left more than staples or remaining carpet padding. Then go around and sink any nails that may be sticking out as these can damage the sanding gear.

Floor Sanding

You need to wear a dust mask and ear protection, sanding your floor may possibly the noisiest, dustiest issue you ever do! You want to start off your sander above the floor and gently lower it down. Be cautious not to gouge your floor, it is not challenging to do. Just bear in mind to be gentle and let the sander sort of float along the surface of the wood. Also make positive you never let the sander sit in 1 spot on your floor, it will leave a swirl mark in seconds that will take you hours to take away.

Sand with the grain of the wood. Move forward and backward over each row so you get a good even sanding. The very first pass is your rough pass, now you want to alter to a medium grit paper and go over the entire location a second time. Then go over the floor again hunting for cracks, gaps and nails. Use putty and sink any nail heads you see.

Now you want to use a palm sander with a fine grit paper for your final sanding pass. Once finished, vacuum the complete region which includes the walls and ceiling. You require to get rid of all particles, dust, and anything else that can stick in the you wood finish. Now it's time to buff. Follow the grain in the wood and start in the middle of the area. Following that your wood floor is prepared to be stained, that's it.B & G Hardwood Flooring 3727 Primrose Ave Santa Rosa, CA 95407 (707) 585-6829 http://bghardwoodflooring.net research hardwood floor installers