PartridgeBroughton90

Clear the Region

You need to have to eliminate every little thing you can from the floor location you are going to refinish. Sofas, curtains, tables, rugs, etc. One more, typically overlooked, essential point is to block as much of the airflo...

Whether or not you have just found a hardwood floor beneath your old carpeting or the wood floor you installed is hunting a tiny beat, refinishing is the very best alternative to bring out it is inner beauty. Right here are the methods you need to take to refinish your floors on your own.

Clear the Region

You want to take away every little thing you can from the floor location you are going to refinish. Sofas, curtains, tables, rugs, and so on. Another, frequently overlooked, crucial thing is to block as significantly of the airflow by way of the location as attainable. Although your finish is drying any airborne particles will stick and turn out to be element of the floor. Something left in the region or these surrounding it ought to be effectively protected whilst sanding. Dust covers and plastic blocking doorways are two of the greatest approaches to achieve this.

Ahead of Sanding

You want to go more than your floor and fill in any cracks or gaps in the wood. Use wood putty in visible locations and caulk along the baseline if necessary. If your floor was beneath carpeting, use diagonal pliers to take away any left more than staples or remaining carpet padding. Then go about and sink any nails that might be sticking out as these can harm the sanding equipment.

Floor Sanding

You require to wear a dust mask and ear protection, sanding your floor may the noisiest, dustiest issue you ever do! You want to begin your sander above the floor and gently reduced it down. Be cautious not to gouge your floor, it is not difficult to do. Just don't forget to be gentle and let the sander sort of float along the surface of the wood. Also make confident you never let the sander sit in one particular place on your floor, it will leave a swirl mark in seconds that will take you hours to get rid of.

Sand with the grain of the wood. Move forward and backward more than every row so you get a good even sanding. The very first pass is your rough pass, now you need to change to a medium grit paper and go over the whole location a second time. Then go more than the floor once more looking for cracks, gaps and nails. Use putty and sink any nail heads you see.

Now you want to use a palm sander with a fine grit paper for your final sanding pass. As soon as finished, vacuum the complete area which includes the walls and ceiling. You need to have to eliminate all particles, dust, and something else that can stick in the you wood finish. Now it is time to buff. Stick to the grain in the wood and begin in the middle of the room. Soon after that your wood floor is prepared to be stained, that is it.B & G Hardwood Flooring 3727 Primrose Ave Santa Rosa, CA 95407 (707) 585-6829 http://bghardwoodflooring.net hardwood floor installers discussion